Planet gear motor installation method

Correct installation, using and maintaining planetary deceleration is an important part of ensuring the normal operation of machinery and equipment.

2022-10-27 18:25:30Zhejiang Dongzheng Motor

Correct installation, using and maintaining planetary deceleration is an important part of ensuring the normal operation of machinery and equipment. Therefore, when installing the planet reducer, be sure to strictly assemble and use it in strict accordance with the relevant matters below.

Step 1

Before installation, confirm whether the motor and the reducer are intact, and strictly check whether the size of each part of the motor and the reducer is matched. This is the size and tolerance of the motor's positioning of the module, the input shaft and the groove of the reducer.

Step 2

Rotate the screws on the outer dust holes of France of France, adjust the PCS system to clamp the ring to align the side holes with the dust holes, and insert the inner hexagonal and spin. After that, take the motor axis key.

Step 3

Connect the motor to the reducer naturally. When connecting, it is necessary to ensure that the overturn output shaft is consistent with the concentricity of the motor input shaft, and the outside flange of the two is parallel. As the heart is inconsistent, the motor shaft is broken or the gear is worn by the gear of the motor.

In addition, when installation, it is strictly forbidden to use hammer and other hits to prevent the axial or radial force from excessive damage to the bearing or gear. Be sure to tighten the installation bolt and then spin the tightly bolt. Before installation, wipe the motor input shaft, positioning convex and reducer's gasoline or zinc sodium water in the connection part of the motor. The purpose is to ensure the tightness of the connection and the flexibility of operation, and to prevent unnecessary wear.

Before the motor is connected to the reducer, the motor shaft key slot should be perpendicular to the tight bolt. In order to ensure uniform force, first spin the installation bolt in any diagonal position, but do not spin, and then rotate the installation bolts of the other two diagonal positions. Finally, tighten the four installation bolts one by one. Finally, tightly tightly bolts. All tight bolts need to be fixed and checked according to the indicated fixed torque torque data.

The correct installation of the correct installation of the decelerator and the mechanical equipment is the correct installation between the slowing machine and the driver motor. The key is to ensure that the output shaft of the reducer is consistent with the concentricity of the driving part.